If you insert same symbol on the same drawing, you may need to swap the blocks (preciously you had issue with) using command AESWAPBLOCK, select option B.Replace NPFA with IEC as shown below (marked in RED), then save and close.Open WD.ENV (in notepad) which is in the AeData folder (along with the Proj and Tutorial folders).Are they IEC or NFPA (I guess they are NFPA)? Click + of the Schematic Libraries to find out the default symbol libraries.In the Project Settings tab click Schematic Libraries then click Default. ![]() Check your project properties: right click project> properties. ![]() ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |